Manufacturers

Bob Smith Industries SUPER-GOLD+ Gap-Filling (1/2oz)

  • Model: BSI126
  • 0 Units in Stock
  • Units at Aldergrove warehouse: 0
  • Manufactured by: Bob Smith Ind

$17.99

Add to Cart:

Bob Smith Industries SUPER-GOLD+ Gap-Filling (1/2oz) 

 

  • Model: BSI126
  • Shipping Weight: 0.125lbs
  • Units in Stock: 50
  • UPC: 707336126007
  • Manufactured by: Bob Smith Industries

About:

SUPER-GOLD Thin and SUPER-GOLD+ gap filling medium thickness are our odorless foam safe CAs. They are non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+. There are no fumes that irritate the nose and eyes. The SUPER-GOLD's do not attack white foam; therefore, they can be used in the building of foam core wings and the assembly and repair of plastic and foam ARF's. They will not fog clear plastic. SUPER-GOLD+ is ideal for attaching clear canopies in plastic model kits; however, MAXI-CURE is still recommended for assembling the rest of plastic kits. Wood can be bonded to white foam with SUPER-GOLD+ in less than fifteen seconds. For bonding foam to foam, spray a very light fog of INSTA-SET to one piece and apply SUPER-GOLD+ to the other before joining. Excess INSTA-SET may create too much heat, which can melt the foam. Both SUPER-GOLD's cure to a more flexible consistency for better shock absorption. Whenever a large amount of CA is to be used in such applications as saturating fiberglass or Kevlar, SUPER-GOLD eliminates the irritating fumes from the evaporating monomer that make repeated use of CA unpleasant at times.

Works Best On:

  • Rubber
  • White Foam

Works Good On:

  • Balsa Wood
  • Soft Wood
  • Hard Wood
  • Glass & Metal
  • Fiberglass
  • Ceramics
  • Hard Plastics
  • Laminating
  • Water-Resistant
  • Reinforcing
  • CA Hinges

Directions:

Unscrew top from nozzle. For finer applications, use the extender tip. Apply Super-Gold+ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set accelerator must be used when bonding two pieces of foam together. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220ยบ F. Soak extender tip in acetone for cleaning.


 

This product was added to our catalog on Friday 01 June, 2018.

Copyright © 2024 RC Pitstop